The name of the 'Client Rules' must be the same as the Server to which the rules refer to. When a IP address is specified, the name of the "Client Rules" should be the same as the IP address.
Movicon Help on Line - Rel. 11.7.1301
The Movicon Networking communication architecture allows two or more stations to connect to each other with the possibility for additional Servers and Clients. When a Client station has to connect to a Server only the settings need configuring through the "Network Client General Properties". But when a Client station must connect to two or more Servers you will need to configure various communication setups between the Client and the various Servers (eg. communication protocols, eventual RAS Stations, etc.). In this situation it would be appropriate to create 'Client Rules' to customize the settings of the Client according to the Server to be connected to. By doing this the Client will be able to connect to the Server by using the 'Client Rules' settings and not the general settings specified in the "Network Client General Properties".
The "Add new Client Rules" command is used for adding 'Client Rules'.
|
|
The name of the 'Client Rules' must be the same as the Server to which the rules refer to. When a IP address is specified, the name of the "Client Rules" should be the same as the IP address. |
